Analog discovery connections

Note: This document applies to REV C of the board. Voice and Fax page of 1. Copyright Digilent, Inc. Other product and company names mentioned may be trademarks of their . Instruments include: Two channel oscilloscope.

Manual” refers to the manual trigger button at the bottom left of the Waveforms window. So how do these parts interact with and change the input signal to give us the output signal? The screen should look . MΩ, ±25V, differential, . How To: Network Analyzer.

Discovery can be configured . While the pinout of the OPand OPare very similar they are not exactly the same, so I had to double-check this before I could make any connections.

In this photo you can see that. Depending on power source (USB or wall wart) and other external connections on the pc, one must be careful with your ground connections. Note that there are two versions of Waveforms. Be able to state how the reference voltage polarity and connection of voltmeter terminals are related to the sign of the measured voltage. There are two options for future CE members: months of . Connect the channel wires to the circuit as shown to the right.

It features a network analyzer function which is perfect for . I have been using the Analog Devices based low cost measurement systems since the Rensselaer Mobile Studio. Also I noticed the breadboard adaptor with the eight connections I need. It is made by Digilent, Inc. You should have a laptop or netbook PC. Get started by installing the software on your PC: – Plug in USB drive.

Software is at the root directory. Double-click on the filename. Within WaveForms, these two channels are represented as AWGand AWG2. M) and series resistor (R).