Searching for a temperature transmitter ? Visit our overview page for temperature transmitters. Our extensive product range provides customizable solutions for a. Temperature transmitters. The continuous analog signal .

Transmitters with LAN or WLAN Interface. The built-in programmable 2-wire transmitter converts the resistance value into a current signal. We have been manufacturing platinum-chip temperature sensors in complex production processes for years. Today JUMO temperature sensors are used in many areas of industry and services where they guarantee consistent, high quality in products.

The 2-wire transmitter uses resistance thermometers or thermocouples to acquire the temperature. C are generally measured using. The plat- inum temperature sensor.

The JUMO dTRANS Trepresents the next generation of 2-wire temperature transmitters that introduce a USB interface for programming. The devices are available as head transmitters, for installation in a DIN terminal head form B ( JUMO dTRANS T05B), as well as for mounting rail installations ( JUMO dTRANS T05T). JUMO is your expert partner and manufacturer for industrial sensor technology up to the automation solution for temperature , pressure, and liquids. The integrated programmable two- wire transmitter converts the resistance value into a current signal. Thermocouple – calculations.

Out of a specified thermoelectric voltage the . JUMO Wtrans Wireless temperature measurement – now with a new transmitter and additional receivers. The Wtrans series from JUMO contains a new transmitter with Mconnection for adaptation to existing . Screw-in resistance thermometers with terminal head Form B. Caution: reduced ambient temperature when using transmitters. JUMO dTRON 30 format 96mm x 48mm (landscape format) incl.

The JUMO Wtrans wireless transmission system as a multifunctional application. Universal receiver for JUMO Wtrans transmitters. Pressure transmitter with wireless data . RTD temperature probes with wireless data transmission.

A controller sends a low-voltage signal through one (B) (A) Figure 26. For types S and R the minimum span is 360°F (200°C) The total error is the sum of the thermocouple wire error (Table 16m) and the transmitter error. The transmitter error is usually 0. An RTD sensor with an integral temperature transmitter may start at approximately $3and depending on its features can rise to more than twice that.

If the temperature of interest is detected by a temperature transmitter , the high or low temperature switch detects a transmitter output signal of 4-mA or 1-V DC.